reversing Lights

Subject: reversing Lights Sun Mar 13, 2011 11:17 am

has anybody done work on the reversing lights...just trying to find the best place to connect to the live feed for a reversing camera on the numberplate..

Subject: Re: reversing Lights Sun Mar 13, 2011 1:22 pm

I just connected the power lead to the reverse light so when put in reverse the lights and the camera both operate

Subject: Re: reversing Lights Sun Mar 13, 2011 8:38 pm

Me as well. Ran the cable from RH tail light down to camera them back up under carpet to front. Seemed easier than tapping in anywhere else

Subject: Re: reversing Lights Sat Mar 19, 2011 10:55 am

yes thats what i was trying to do...run from the reversing light feed...its a bit of a cow to get too though...you cant remember what colour the cable was ??

Subject: Re: reversing Lights Sat Mar 19, 2011 6:43 pm

I just pulled the light assembly out and patched in there.

Subject: Re: reversing Lights Mon Mar 21, 2011 2:23 pm

how does it come out ??

Subject: Re: reversing Lights Mon Mar 21, 2011 10:37 pm

there are 2 screws that have to be undone then the light folds out and pulls away from the body assembly is just a reverse of this. also i found a little hole underneath that allowed me to feed the wires required through making the job a lot neater not sure if this is on all sc's. Very Happy

Subject: Re: reversing Lights Tue Mar 22, 2011 3:28 am

Good one mate, beat me to it. I didn't use the hole just taped up the wires and bought them in under the rubber. There is a hole in the floor inside that I did use tho.

» Location of Fuse 21 -Tail lights and the Dash Lights
» Tail lights, dash lights, f int lights, pk lights not going
» Parking lights not working & warning lights won't turn off
» Dash Lights + Fog Lights + Rear Tail Lamps ALL gone at once
» Aftermarket tail lights, brake lights stays on...